![]() This gives fewer and more uniform linking paths. ![]() Added Blend toolpath joining in more cases if the endpoints are aligned.Fixed possible small gouges in Blend, Flow and Multi-axis contour.Fixed a failed toolpath calculation in Blend which occured in some instances where machining boundaries were used.Fixed a possible holder gouge in Blend and Flow strategies with enabled "Trim" option in holder protection.When the toolaxis hits the limit, it will decelerate to a stop rather than stopping suddenly. Added damping for toolaxis limits in Blend and Flow with a non ball tool.Fixed an issue in Flow operations where the toolpath might not be machined if the tilt angle was exceeded on a machine with limited axial motion.Fixed a case when Contour2D could fail to generate toolpath for narrow slots with ramp linking.Fixed a bug when "finishing feedrate" might not apply to last finishing path. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |